All right.
So let's start out by making our little teleportation unit.
And I have a cylinder.
I'm going to select that, add it to the world.
If you want to rotate this, it's on the ground.
Make sure your collisions are off or it's going to get stuck in place.
There we go.
I'm going to call this base and let me change the size.
So go down to size.
I'll make this 0.2 by eight by eight.
Now I'll turn collisions on and I'll push it on the ground.
There we go.
Undo control DX to duplicate.
That's going to be the roof.
Let's call that roof
and I'll duplicate this again.
Controlled D.
This is going to be the pad, the glowing part.
I'm going to call a pad A right.
So I'm going to make that a little smaller and I'll make it green and glow.
We can make it green and glow right away.
Break color, lime green.
And for material, I'm going to make a neon.
There we go.
And then I'll make the size a little different.
I'll make it 0.1 by six by six.
Nice and we're going to have a cooldown too.
So this is going to turn gray when it's not available.
All right, let's do a controlled RD to duplicate that.
Push this up here just a little ways.
I'm going to call this.
I'll call this roof.
Also roof.
It's going to be part of the roof.
We're not going to need these.
We're only going to need pad A.
So pad A, pad B and pad C are going to be the places we teleport to.
I'm going to grab the base C, I've got base selected and do a controlled D, and I'm going to change
the size of that.
This is going to be one of my supports.
I'm going to make this ten by 0.5 by 0.5.
There we go.
I'm going to move this over and then I push it to the base.
They're going to turn collisions off control D to duplicate in place.
Move this over here.
Let's go eyeball it.
There we go.
I'm going to get this green thing right here.
I turn collisions back on.
Plop that up against my roof.
So both roofs are touching.
I'm going to control.
Click the other roof part.
And then push that down.
Here we go.
That's not so bad.
Let's go ahead and select all of the parts.
So remember, only Pat A has to be unique.
So we've got a couple of bases.
I think I might actually change these to support, though, even though they don't have to be unique
support.
And then I'll just click this one here, make that one support also.
All right.
Now we'll get the base all the way down to the roof shift click and let's make anchor it so it doesn't
fall apart.
Anchored.
I'm going to right click and I'll do group as model.
Here we go.
And this is going to be Tela Porter A.
All right.